Clutch Installation - Victory Cross Roads Classic Service Manual

CLUTCH, PRIMARY, & SHIFT LINKAGE

Clutch Installation

1. Pry back split gear (B) to align teeth and push clutch
assembly onto clutch shaft until gear is fully engaged
with torque compensator gear.
2. Clean clutch shaft threads with Loctite™ Primer N to
remove all grease, oil, or old locking agent.
3. Install washer (C), a new spring washer (D) and a new
stake nut (E). Install spring washer with yellow dot
facing OUT. See chapter 10 for stake nut installation.
9.20
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
Install with yellow dot facing OUT
4. Install lock tool under split gear or lock crankshaft as
shown on page 9.12. Torque nut to specification.
Engine lock tool PV-43502-A
5. Install clutch lifter assembly (F) and retaining ring (G).
Be sure retaining ring is seated in groove.
6. Install primary cover (page 9.12).
7. Check engine oil and fill to proper level.
© Copyright 2012 Polaris Sales Inc.
C
B
D
F
= T
Clutch Stake Nut: 125 ft-lbs (170 Nm)
Replace with new
125 ft-lbs (170 Nm)
E
G