Swingarm Service; Swing Arm Removal - Victory Cross Roads Classic Service Manual

9. Lift debris flap into position and engage top tab (C) in
slot (D) of frame.
D
10. Route air line fitting between fender and frame on right
side.
11. Lift bottom edge of inner fender up and push it forward
until corner tabs (E) are engaged with notches in the
frame. Do not push lower tabs past the frame notches.
Be sure the top tab is still properly engaged on top of
rear frame opening.
E
12. Install subpanel and reconnect purge valve lines,
purge valve connector, flasher harness and fuse box.
13. Route the air line fitting through the hole in the right
sub-panel, install nut and torque to 84 in-lbs (9.5 Nm).
14. Install seat, side covers and saddlebags. (Chapter 3)
15. Bounce test suspension to check for proper operation
before test ride.
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
C
© Copyright 2012 Polaris Sales Inc.
REAR WHEEL & SUSPENSION

SWINGARM SERVICE

Swing Arm Removal

WARNING
Swingarm removal involves supporting the machine with
the rear end elevated. Take precautions so that the
motorcycle is securely supported while the rear tire is off
the ground. Severe personal injury or death can occur if
the motorcycle tips or falls.
1. Secure front tire in the wheel vise of a motorcycle
table lift.
2. Remove seat, both side covers, and both saddlebags
(Chapter 3).
3. Place a wide-based platform jack under rear of engine.
Elevate the jack slightly until weight is removed from
rear wheel.
4. Loosen left muffler crossover pipe clamp and left
muffler with shields attached.
5. Remove left passenger footrest bracket and remove
brake line guide from swingarm.
13
13.25