Neutral Switch Bypass Test - Victory Cross Roads Classic Service Manual

2012-2013
Table of Contents

Advertisement

ELECTRIC STARTER

Neutral Switch Bypass Test

The symptom of a faulty neutral indicator switch / circuit
is:
• Starter motor does not operate when transmission
is in neutral with clutch lever released but does
operate with the clutch lever pulled in.
1. Turn ignition switch on and place engine stop switch
in the RUN position.
2. Shift transmission into Neutral.
3. Observe neutral indicator light.
4. If indicator is not working with transmission in neutral:
• Disconnect neutral indicator switch (B).
NOTE: When
the
Neutral
disconnected, the multi-function display (MFD) will
display (---) regardless of gear position (with Key
ON).
• Connect Black/Pink of harness side connector pin
to ground on engine (not switch side of connector)
with a jumper lead. This provides a path to ground
for the neutral light.
B
TABLE 1 - TESTING NEUTRAL PORTION OF NEUTRAL INDICATOR SWITCH
Gear Position
Neutral
Any Gear - Other Than
Neutral
* Be sure to subtract meter probe resistance from resistance reading
18.8
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
Indicator
Switch
is
Meter Probe # 1
Black/Pink
(switch side of connector)
Black/Pink
(switch side of connector)
© Copyright 2012 Polaris Sales Inc.
5. If the neutral lamp comes on, the neutral indicator
switch or wiring between connector and switch is at
fault. Continue to Step 6 to test the neutral indicator
switch.
6. Set meter to measure resistance.
7. Place one meter lead on Black/Pink wire on switch side
of connector.
B
8. Connect the other lead to engine ground.
9. Compare reading to Table 1 below.
10. Replace neutral switch or repair wiring as necessary.
11. If neutral switch is working correctly and neutral
indicator did not light with the harness wire grounded,
inspect neutral lamp circuit wiring and connectors for
an open circuit.
If switch is faulty, refer to Neutral Indicator Switch
Removal / Installation (Chapter 19).
Meter Probe # 2
Crankcase (ground)
Crankcase (ground)
Ohmmeter Reading*
< .5
OL

Advertisement

Table of Contents
loading

Table of Contents