Victory Cross Roads Classic Service Manual page 487

BATTERY CHARGING SYSTEM
A battery will self-discharge when the motorcycle is not in
use. Make sure to properly store the battery as outlined
later in this section.
Maximum voltage and service life is only achieved when
the battery is properly serviced initially. Make sure to follow
instructions outlined later in this section.
Overcharging can be caused by a faulty battery (shorted
cell). Test system with a known good battery when
diagnosing an overcharge condition.
New batteries must be properly maintained as outlined in
this section to ensure proper service life.
CONNECTING AND DISCONNECTING THE
BATTERY
Always disconnect the negative battery cable first
when removing the battery.
Always connect the positive battery cable first when
connecting the battery.
If corrosion is found on terminals, remove battery
and clean terminals with a solution of baking soda
and water. Finish the process by cleaning terminals
(both battery and battery cables) with a wire brush.
Once connections are secured, apply a thin film of
Nyogel™ grease to the terminals.
Verify the positive terminal has it's protective boot in
WIRE ROUTING
Make sure that all wires are routed correctly.
Fuses are in place to protect circuit wiring and
components. Always determine the cause of an
open fuse before installing a new fuse.
Do not increase the value of the fuse to correct the
Do not use wire, tin foil or other substitutes for fuses.
16.6
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
CAUTION
place.
CAUTION
CAUTION
FUSES
problem.
© Copyright 2012 Polaris Sales Inc.
ELECTRONIC COMPONENTS
Semiconductor parts used in electronic components
will not withstand careless handling.
Do not drop or strike parts that contain
semiconductors such as the ECM or rectifier/
regulator. Dropping electronic components can
cause damage to the component.
Follow instructions supplied in this chapter, including
chapter 5 (Fuel Injection) and chapter 17 (Ignition
System), very carefully when working on electronic
components. Failure to follow instructions may
cause irreparable damage to the part being
inspected.
SPECIAL TOOLS
The following tools are available for purchase from our tool
supplier, SPX:
Engine Stop Tool: PV-43502
Flywheel Puller: PV-43533
Digital Multi-Meter: PV-43546
Connector Test Kit: PV-43526
Battery / Conductance Tester: MDX - 610P
CAUTION