Headlight Aim Inspection; Headlight Aim Adjustment - Victory Vegas Jackpot Rider's Manual

Maintenance

Headlight Aim Inspection

The top edge of the high beam must be 3 inches
(7.6 cm) below the height of the headlight hous-
ing parting line and centered straight ahead at 25
feet (7.6 m).
1. Verify that tire pressure is at specification.
See page 69.
2. Verify that rear suspension ride height
(preload) is at specification. Include rider,
passenger (if applicable) and cargo when
setting preload. See page 59.
3. Position the motorcycle on a level surface
with the headlight 25 feet (7.6 m) from a wall.
With the operator and passenger (if applicable) on board, bring the motorcycle to the
fully upright position.
4. Move the ignition switch to the ON position and switch the headlamp to high beam.
Observe the headlight aim on the wall.
5. Make any necessary adjustments to headlight aim.

Headlight Aim Adjustment

1. To adjust the headlamp vertically, hold the headlamp
firmly while loosening the adjustment bolt. Adjust
the headlamp and hold it firmly in position while
tightening the bolt.
Torque: 35 ft-lbs (47.5 Nm)
2. To adjust the headlamp horizontally, loosen the
horizontal adjustment nut. Adjust the headlamp and
hold it firmly in position while tightening the nut.
Torque: 28 ft-lbs (38 Nm)
3. Verify proper headlight aim. Readjust if necessary.
78
25 ft. (7.6 m)
3 in. (7.6 cm)
Height of headlamp
housing parting line
Vertical
Adjustment
Bolt
Horizontal
Adjustment
Nut
High Beam