Triple Clamp Removal - Victory Cross Roads Classic Service Manual

Table of Contents

13. Screw nut upward until it contacts the cap.

14. Tighten nut against cap. Hold nut and torque cap to

9.5 - 12.0 ft-lbs (13-16 Nm).

15. Screw cap into outer tube and torque to specification:

11-22 ft-lbs (15-30 Nm).

16. Wipe fork clean to remove all oil before installing in

triple clamp (page 12.11).

Triple Clamp Removal

1. Remove windshield (Cross Roads) or front fairing

assembly (Cross Country).

2. Remove speedometer from top triple clamp (Cross

3. Cut tie straps (A) on handlebars.

9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual

FRONT SUSPENSION / CONTROLS

4. Loosen crown nut (B).

5. Remove headlamp cover screws (C, both sides) and

cover (Cross Roads).

6. Remove fuel tank (page 5.15) or cover the tank to

protect it tank from damage from brake fluid, loose

parts, or handlebar switches (fork stop will not function

with fork tubes removed).

7. Disconnect clutch cable at handlebar.

8. Disconnect switch wiring inside headlamp.

9. Remove throttle cables from throttle reel bracket and

from throttle reel. Pull cables through top triple clamp.

10. Securely support the vehicle with front wheel

Care should be taken to be sure the motorcycle will

not tip or fall while elevated. Severe personal injury

or death could occur if the motorcycle tips or falls.

11. Remove front wheel (page 12.26) and fender

(page 12.9).

12. Remove fork tubes (page 12.30).

Table of Contents