Rear Shock Removal - Victory Cross Roads Classic Service Manual

Table of Contents

REAR WHEEL & SUSPENSION

Rear Shock Removal

Shock absorber removal involves supporting the

machine with the rear end elevated. Take precautions so

that the motorcycle is securely supported while the rear

tire is off the ground. Severe personal injury or death can

occur if the motorcycle tips or falls.

1. Secure the front tire in the wheel vise of a motorcycle

table lift and stabilize with tie-downs.

2. Remove seat, both side covers, and both saddlebags

(Chapter 3).

3. Place a wide-based platform jack under rear of engine.

Elevate the jack slightly until weight is removed from

rear wheel, but tire still contacts the table surface.

4. Remove lower shock and push-rod bolts (A) from

9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual

5. Lower the inner rear fender (B) and detach shock air

line and vent hose from plastic clips.

6. Disconnect purge valve lines (C), purge valve

connector (D), flasher harness (E) and detach fuse box

(F) from right subpanel.

7. Remove jam nut (G) securing air valve to subpanel and

cut tie strap (H). Withdraw air valve from subpanel.

Table of Contents