Victory Cross Roads Classic Service Manual page 57

MAINTENANCE
7. Disconnect fuel line from pump by squeezing release
tabs (G) on both sides of the fitting. Pull fuel line straight
down off pump fitting.
Tie Strap
Don't Remove
8. Install fuel tank fitting plug tool PV-50251(9.5mm
fittings) or PV-50567 (11.8mm fittings) onto fuel pump
fitting to protect the fitting and prevent fuel for seeping
out of tank.
9. Grasp tank at front edge. Lift rear of tank high enough
for the fuel pump fitting and the plug tool to clear the
frame.
10. Carefully pull tank rearward to release front tank
mounts from front isolators.
11. Place tank on suitable flat surface that will not scratch
fuel tank. Do not place fuel tank on frame/seat area of
the motorcycle.
2.6 2.6
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
G
Install Special Tool
PV-50251 or PV-50567
© Copyright 2012 Polaris Sales Inc.
12. Loosen (3) filter retainer screws (E).
13. Loosen (2) filter mount screws (F) only until filter can
be removed. Do not remove screws from filter.
F
36 in-lbs
(4.0 Nm)
14. Lift retainer up, then lift filter and slide it rearward to
remove.
Lift retainer up,
Pull filter up and out
Air Filter Installation
15. Clean filter sealing surface on frame.
16. Install new air filter with captive screws. Check edges
of filter to be sure they are seated properly in flange.
17. Tighten filter mount screws and retainer screws. (4.0
Nm or 36 in-lb)
18. Reinstall fuel tank by performing steps 1-14 on the next
page.
E
36 in-lbs
(4.0 Nm)