Wheel Bearing Installation (Typical) - Victory Cross Roads Classic Service Manual

Wheel Bearing Installation (Typical)

1. Clean inside of wheel hub and bearing spacer.
Replace spacer if worn beyond the service limit.
Standard: 171.30 - 171.50 mm (6.744 - 6.752
Service Limit: Less than 171.30mm (6.744
Cast, Billet and Spoked
Wheel Bearing Installation Set PV-43515
2. Slide threaded rod from PV-43515 through wheel hub.
Place new wheel bearing (A) into left (disc) side of
wheel with markings facing out (toward outside of hub).
3. Assemble tool with flat side of 51mm wheel bearing
collar (B) against wheel bearing. This tool must be
slightly smaller than O.D. of bearing and must be flat
to support both inner and outer race equally. DO NOT
pull or press on inner race of ball bearings or bearing
will be permanently damaged!
4. Install tool bearing (C), washer (D), and nut (E) on
threaded shaft.
E D C
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual

)

)
B
A
© Copyright 2012 Polaris Sales Inc.
REAR WHEEL & SUSPENSION
5. Install the other 51mm bearing tool (F) in bearing bore
on right side of hub with flat washer and nut. Pull left
bearing into hub by tightening nut on left side of tool
until left bearing is fully seated in hub.
NOTE: DO NOT install retaining ring at this time.
6. Turn wheel over and install bearing spacer (G). Be sure
spacer is centered on bearing.
F
G
13
13.13