Victory Cross Roads Classic Service Manual page 381

FRONT SUSPENSION / CONTROLS
FORK SPRING INSTALLATION / FINAL ASSEMBLY
WARNING
Springs are compressed during this procedure.
Wear a face shield to reduce the chance of injury.
1. Set axle end of fork tube in spring compressor.
2. Install lower spring (spring is non-directional).
3. Install lower spacer.
4. Install upper spring (A) (spring is non-directional).
5. Engage all 3 pins (B) of compressor tool with coils of
fork spring as done for disassembly.
6. Screw cartridge rod extension tool (C) onto cartridge
rod and pull cartridge up to top of travel range.
7. Compress spring. Guide damper rod with extension
tool while spring is being compressed.
B
8. Hold damper rod up and remove cartridge shaft tool.
12.40
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
9. Install top spacer on spring.
10. Install nut with flattest surface facing up.
11. Screw nut onto cartridge rod at least 17 mm to ensure
A
12. Install a new O-ring on fork cap and screw cap onto
C
B
© Copyright 2012 Polaris Sales Inc.
cap threads will be fully engaged when installed.
cartridge rod until bottomed. A gap should exist
between cap and nut when cap is bottomed.
17mm (minimum)
Bottom cap on
damper rod.