Fork Oil Filling / Level Setting - Victory Cross Roads Classic Service Manual

Table of Contents

FRONT SUSPENSION / CONTROLS

Fork Oil Filling / Level Setting

1. Slide tubes together lightly to bottom of travel range.

2. Tip fork leg at an angle to reduce bubbles when

adding fork oil.

ADD: About 500 cc of P/N 2877421 fork oil.

3. Slowly add recommended fork oil until holes near the

top of the outer tube are covered by oil. (The holes are

located about 35mm (1 1/2 inches) below the top of

the outer tube).

capacity. Final fork oil level must be adjusted

correctly as outlined later.

9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual

4. Set fork leg upright.

5. Lift outer tube up about 100-125mm (4-5 inches) from

fully compressed position.

6. Seal top of tube firmly with your hand and push

downward to build air pressure in tube. Hold for 10-

15 seconds to force trapped air into the oil. Allow a few

minutes for air to rise to the top of the oil in tube.

7. Bleed cartridge by moving shaft up and down to purge

air. Begin with small strokes, increasing stroke length

until all air is removed and damping is smooth and

Table of Contents