Victory Cross Roads Classic Service Manual page 361

FRONT SUSPENSION / CONTROLS
11. Remove cables from throttle grip. Do not kink or bend
the cables. Do not attempt to slide the grip off the end
of the handlebar with cables attached.
12. Grasp left handlebar end cap by with an adjustable
pliers and twist to remove.
13. Remove left hand grip.
Heated Grips: Fold back edge of grip and remove set-
screws.
Non-heated grips: Insert a thin screw driver between
grip and bar to release adhesive bond. A small
amount of solvent can be used to help loosen the
adhesive. DO NOT
CONTACT COSMETIC SURFACES!
14. If handlebars will be reinstalled, remove any residual
adhesive from bar with solvent.
12.20
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
ALLOW SOLVENT TO
© Copyright 2012 Polaris Sales Inc.
15. Disconnect clutch interlock switch wire connector and
remove clutch lever perch.
16. Remove audio / com switches (if equipped) and
bracket.
17. Remove left handlebar switch.
18. If handlebar risers will be removed, remove
handlebars / risers as an assembly. If risers will not
be removed, support the handlebars and loosen the
rear handlebar clamp screws, and then the front.
Remove handlebars.