Victory Cross Roads Classic Service Manual page 405

REAR WHEEL & SUSPENSION
7. Assemble tool through left side with backing disc (or
bearing tool) flat against left bearing. Be sure the tool
supports both inner and outer race.
Left Side
8. Place new wheel bearing (H) on threaded shaft
(markings out) and start it squarely in the hub.
9. Install 51 mm wheel bearing installation tool with flat
side against bearing, followed by tool bearing, flat
washer, and nut.
10. Keep the wheel positioned as shown to keep spacer
centered during installation of right bearing.
Typical Wheel Assembly Shown
11. Pull bearing in to right side of wheel until seated against
spacer.
13.14
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
Right Side
H
© Copyright 2012 Polaris Sales Inc.
12. Remove tool and check that the spacer is centered and
firmly trapped between bearing inner races. If it is not,
center it using the rear wheel axle and repeat Steps
9 - 11 to fully seat the bearing against spacer.
13. Install snap ring. Be sure it is fully seated in groove.
14. Rotate inner races of bearings to check for free,
smooth rotation.
15. Install new seals using a 52 mm seal driver.
Seal Depth
16. Install brake disc (page 13.15). Clean discs with
Victory Disc Brake Cleaner.
Do not allow brake cleaner to contact painted surfaces.
WARNING
Grease or oil on the brake disc or pads will increase
stopping distance which could cause a loss of control
or a crash.
17. Install rear sprocket (page 13.16).
1.5 mm (.059 in.)
CAUTION