Vehicle Speed Sensor Test; Neutral Indicator Switch Test; Memory Check Sum Error; Tipover Sensor - Victory Cross Roads Classic Service Manual

Vehicle Speed Sensor Test

To view and clear trouble codes refer to page 5.36. See
page 5.35 for wire colors / pin number in connector.
1. Refer to Chapter 19 to test the speed sensor, located
on the crankcase behind the rear cylinder (A).
A

Neutral Indicator Switch Test

1. Refer to Digital Wrench and Chapter 19 to test the
neutral indicator switch on the vehicle. The harness
connector is located at the top of the engine
crankcase behind the side covers (near the speed
sensor).
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
FUEL SYSTEM / FUEL INJECTION

Memory Check Sum Error

To view and clear trouble codes refer to page 5.36. See
page 5.35 for wire colors / pin number in connector.
FAIL CODE: P0601
COMPONENT AFFECTED: ECM
Module Memory Check
Sum Error when installing
new ECM.
NOTE: All new ECMs have the "Memory Check Sum
Error" at first power-up after the memory is loaded
into the ECM. This code must be cleared when the
ECM is initialized. If this code appears when using
the diagnostic software, it is possible that a new ECM
was not cleared successfully. If this is the case, the
code may be present without an actual fault.
1. If Trouble Code message P0601 (Internal Control
Module Memory Check Sum Error) is present when
using the diagnostic software, first record any other
faults present, then try clearing the P0601 trouble
code.
2. If the code reappears, further inspection is required;
however, it is more likely the code was not cleared from
memory during initialization, and will not be present
after it is cleared.

Tipover Sensor

Refer to Chapter 19 and Digital Wrench for tipover sensor
information.
© Copyright 2012 Polaris Sales Inc.
INDICATES INSPECT / ACTION
Clear code and check to
see if code re-appears
5
5.47