Tachometer Signal Test; Speedometer Gear Position Indicator - Victory Cross Roads Classic Service Manual

Table of Contents

Tachometer Signal Test

• The Tachometer signal is delivered on the CAN bus 6 pin connector to the gauge. This test will verify that the

tachometer signal is getting to the gauge. To test for tach signal:

1. Turn the ignition key ON.

2. Turn the cruise control OFF (Press OFF button).

3. Turn the ignition switch OFF.

4. Be sure transmission is in NEUTRAL.

5. Turn the ignition key to the ON position and start the engine. Hold the RES/ACC button down while you press the

cruise control ON button.

6. Release both buttons. If a tachometer signal is present, the cruise indicator lamp should flash at a rate based on

engine RPM. Rev the engine. The rate of flash should increase with RPM.

For model years 2011-2013, ALL Victory Motorcycles with a gear indicator display will show dashes (---) if the clutch lever

is pulled in (clutch disengaged). The gear indicator system uses multiple inputs to show the gear number 1 through 6.

ALL of the following items must be present for gear indicator function:

• Vehicle ignition and run / stop switch are powered and the engine is running.

• Vehicle is in motion.

• Vehicle clutch lever is released (clutch engaged).

• Vehicle transmission is in gear 1 through 6 (not neutral).

9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual

WIRING / LIGHTING SYSTEMS

Table of Contents