Engine Attachments & Notes - Victory Cross Roads Classic Service Manual

Engine Attachments & Notes
29. Route oil pressure sensor wire behind engine and
toward the sensor on the left rear crankcase. Attach
sensor wire to sensor and secure it to the left rear
crankcase with a tie strap through hole (F) provided.
F
30. Install throttle cables onto cable bracket (dark cable
is PULL cable and located on the bottom). Torque
nuts to 48 in-lbs (5.4 Nm). Adjust cable free play
(page 2.11).
31. Connect cruise cable to throttle reel (if equipped) and
snap cable securely into bracket.
32. Route wire harnesses to general location and
connect:
- Ground wires to left rear crankcase 87 in-lbs (9.8
Nm).
- Engine temperature sensor
- TMAP sensor
- CPS
- Speed sensor
- TPS
- Horn and bracket
33. Install engine breather hose.
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
ENGINE REMOVAL & INSTALLATION
34. Loosely install front left and right frame cradles with
alignment pins (G) and M10 bolts (H).
35. Move rear brake line, battery box, and master cylinder
to general mounting location.
36. Install a new dart strap for brake line (if removed) to
right rear side of battery box.
37. Loosely install (3) screws (I) & (J) through front of each
frame cradle to battery box.
J
I
85 in-lbs
(9.6 Nm)
H
35 ft-lbs
(47.5 Nm)
38. Fully tighten left and right frame cradle bolts (H) to
engine.
39. Fully tighten left and right battery box screws (I & J).
40. Install starter motor lead and torque to 60 in-lbs (6.8
Nm).
41. Install regulator/rectifier to engine (if removed) and
torque fasteners to 85 in-lbs (9.6 Nm). Connect 3-Pin
stator connector.
42. Install harness ground wires and regulator rectifier
ground wire to engine. Torque screw to 85 in-lbs (9.6
Nm).
43. Attach removed wires to circuit breaker terminal and
torque nut to 25 in-lbs (2.8 Nm).
© Copyright 2012 Polaris Sales Inc.
22 in-lbs
(2.5 Nm)
19 ft-lbs
(25.7 Nm)
48 in-lbs
(5.4 Nm)
G
Front 6
H
6.15