Engine Oil Level; Engine Oil And Filter Change - Victory Cross Roads Classic Service Manual

MAINTENANCE

Engine Oil Level

1. Warm the engine for several minutes until operating
temperature is reached.
2. Stop engine and wait for 3-5 minutes.
3. Place the machine on a level area and hold it in an
upright position.
4. Remove dipstick (A) and wipe it clean.
A
5. Screw dipstick in until seated.
6. Remove dipstick and view oil level.
7. Oil level should be between ADD and FULL lines on
dipstick. If oil level is low, add Victory 20-40 Semi-
Synthetic engine oil to raise level to FULL mark. DO
NOT overfill.
1/2 qt.
Screw in to check
2.8 2.8
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual

Engine Oil And Filter Change

Change engine oil at intervals listed in the Periodic
Maintenance Table.
1. Start and run engine until it reaches normal operating
temperature. Stop engine.
2. Securely support motorcycle on sidestand.
3. Place an oil drain pan under drain plug (B) and filter (C).
4. Remove drain plug (6mm Allen wrench) and allow oil
to drain completely.
5. Remove oil filter with a 2 1/2 inch (63.5 mm) filter
wrench.
6. Clean drain plug sealing surface on crankcase.
Replace seal washer on drain plug.
7. Install drain plug and tighten to proper torque. DO NOT
overtighten.
8. Clean oil filter gasket sealing surface on crankcase.
9. Make sure new oil filter gasket is properly seated in the
new oil filter, and apply a thin film of clean engine oil
to the gasket. Screw new filter on until gasket contacts
the filter mounting plate. Tighten filter by hand an
additional 3/4 turn.
(Cont.)
© Copyright 2012 Polaris Sales Inc.
B 15 ft-lbs (20 Nm)
C