Switch Testing; Rear Brake Light Switch Test; Front Brake Light Switch Test - Victory Cross Roads Classic Service Manual

Table of Contents

WIRING / LIGHTING SYSTEMS

SWITCH TESTING

NOTE: The rear brake switch can also be tested by

following the cruise control self-diagnostic procedure on

page 19.23 (if equipped with cruise).

1. Remove left highway bar and left outer chin fairing.

2. Disconnect rear brake light switch wires (B).

3. Connect ohmmeter to switch contacts.

4. Apply light pressure to rear brake.

5. The switch should become conductive (resistance less

than 2 Ohms) as soon as brake pedal resistance is felt.

SPECIFICATION: Continuity When Brake Applied

9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual

1. Disconnect wires (A) from switch.

2. Connect ohmmeter to switch contacts and test for good

SPECIFICATION: Continuity When Brake Applied

NOTE: The front brake switch can also be tested by

following the cruise control self-diagnostic procedure on

page 19.23(if equipped with cruise).

micro switch

located on front

brake lever perch

continuity through switch when front brake is applied.

located above oil filter

Table of Contents