Headlamp Aim Inspection - Victory Cross Roads Classic Service Manual

7. Rotate the wheel BACKWARD. Tighten LEFT rear axle
adjuster until belt begins to track to right sprocket
flange (outboard) during backward wheel rotation.
Rear Wheel Alignment - Final
8. Rotate the wheel in FORWARD direction. Loosen
LEFT rear axle adjuster until belt moves off the right
sprocket flange and begins to track to the left flange
(inboard) during forward wheel rotation.
9. Tighten rear axle nut to 65 ft-lbs (88 Nm).
10. Torque both axle adjuster nuts to 8 ft-lbs (11 Nm).
11. Pump rear brake pedal several times to reset brake
pad distance.
12. Verify wheel rotates smoothly and freely without drag
when brake pedal is released.
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual

Headlamp Aim Inspection

The top edge of the high beam must be 3 inches (7.6 cm)
below the height of the widest part of the headlight and
centered straight ahead at 25 feet (7.6 meters).
To check for proper headlamp aim:
• Set tire pressure (page 2.10) and rear
suspension air pressure for load (page 2.31).
• Straddle motorcycle in an upright position
and sit in the operator's seat.
• Turn ignition switch ON.
• Select HIGH BEAM.
• Compare to illustration and adjust if necessary.
Cross Roads / Hard-Ball
© Copyright 2012 Polaris Sales Inc.
MAINTENANCE
Wall
25 feet (7.6m)
3 in. (7.6 cm)
Height of widest
part of headlamp
(housing parting line)
Floor
Cross Country
Wall
25 feet (7.6m)
3 in. (7.6 cm)
Height of widest
part of headlamp
Floor
2
2.27