Idle Air Control Removal - Victory Cross Roads Classic Service Manual

Idle Air Control Removal

Also refer to IAC Assembly View on page 5.13.
1. Remove RH cover and IAC cover.
2. Remove wire dart (A).
3. Push tab (B) to disconnect IAC harness.
4. Remove (4) IAC bracket screws (C) using a 5mm ball
drive hexagonal socket.
A
5. Remove high tension leads (D) from coils.
NOTE: The front HTL is routed behind the ignition
switch cover, not above it upon assembly.
D
6. Remove (4) bracket screws with a 5mm ball drive
hexagonal socket.
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
FUEL SYSTEM / FUEL INJECTION
7. Lift tab of primary wire harness connector to detach it
from the ignition coil.
C
B
8. Push tab on ignition switch connector and remove
bracket with switch attached.
9. Remove air supply hose from air box, the front air
delivery hose, and the rear air hose with "T" fitting from
throttle body.
NOTE: Restricted side of tee fitting faces purge valve
on California models. On 49 state models, the
restricted side of the tee fitting is plugged (E).
© Copyright 2012 Polaris Sales Inc.
5
E
5.29