Multi Function Display - Cross Country (Mfd); Engine Error Codes (Cross Country) - Victory Cross Roads Classic Service Manual

SPECIFICATIONS / GAUGE / AUDIO
Multi Function Display (MFD)
(Cross Country)
Use the MODE button (page 1.27) to toggle through the
modes of the MFD. To change display units (metric) see
page 1.26. Permanent and trip computer modes are
described on the following pages.
PERMANENTLY DISPLAYED MODES:
• Clock (A)
• Gear Position (B)
• Ambient Temperature (C)
TRIP COMPUTER (D) MODES*:
• Odometer
• Trip Odometer 1 & 2**
• Average Fuel Economy**
• Average Speed**
• Fuel Range
• Instantaneous Fuel Economy
• Trip Hours Meter**
**Press and hold the mode button to reset.
A
D
1.24
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
B
C
© Copyright 2012 Polaris Sales Inc.

Engine Error Codes (Cross Country)

The error screen displays only when the check engine
(MIL) light is on or when it goes on and off during one
ignition cycle (key on / key off cycle). Error codes are not
stored. When the key is turned off, the code and message
is lost, but it will reappear if the fault occurs again after
starting the engine.
If the MIL light illuminates, retrieve the error codes from the
display or connect Digital Wrench to view historic and
current fault codes (Chapter 5).
To retrieve error codes from the display:
1. If the error codes are not displayed, use the mode
button to toggle until "Err" displays in the clock area.
2. Record the three code numbers displayed in the gear
position, temperature, and odometer displays.
3. Refer to Chapter 5 for a list of codes.
Error Code
Number (0-9)
"Err"
Suspect Parameter Number (SPN)
Failure Mode
Indicator (FMI)