Drive Sprocket Inspection; Drive Sprocket And Seal Installation - Victory Cross Roads Classic Service Manual

DRIVE LINE / REVERSE SYSTEM
6. Rotate crankshaft (arrow) using Crankshaft Rotation
Socket PV-48736 until key way is aligned with one of
the TDC holes in crankcase.
7. Insert an 8mm or 5/16
hole and into crankshaft to hold shaft while loosening
sprocket nut.
8. Remove sprocket nut.
9. Loosen rear axle nut.
10. Loosen both axle adjusters an equal amount of turns.
11. Push wheel forward until belt is loose.
12. Pull belt off sprocket.
13. Remove front sprocket, spacer, and O-ring from
output shaft.
14. If required, remove shaft seal using a suitable tool.

Drive Sprocket Inspection

1. Visually inspect sprocket teeth (A) for excessive
wear, foreign material damage.
B
2. Inspect splines (B) for a tight fit on output shaft splines.
11.6
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
Use Tool
PV - 48736

diameter pin into crankcase
Remove drive
A
sprocket cover
C
© Copyright 2012 Polaris Sales Inc.
3. Inspect the back surface of sprocket hub (C) where it
contacts the seal sleeve. Replace if worn or if surface
is rough.
4. Inspect outer surface (D), inner surface (E), and
sealing surface (F) of seal sleeve. Surfaces must be
flat without wear or galling. Replace the sleeve if worn,
or if the surface appears rough or chafed. The O-ring
sealing surface of slightly chamfered edge must be
smooth to seal the shaft.
D
Seal Sleeve

Drive Sprocket And Seal Installation

1. Apply grease to a new O-ring (G) and install on output
shaft.
2. Install the shaft seal (if removed) using special tool
PV-43505A.
G
H
Installation: Tool PV-43505A
3. Install seal sleeve (H) with the chamfer on inside
diameter of sleeve facing in, toward O-ring.
F
E