Rectifier / Regulator Replacement - Victory Cross Roads Classic Service Manual

BATTERY CHARGING SYSTEM

Rectifier / Regulator Replacement

1. Remove center chin fairing (page 16.3) and electrical
cover.
2. Lift cover off circuit breaker and remove positive
regulator / rectifier lead from battery side terminal of
breaker.
3. Remove ground screw from left front of crankcase and
remove negative regulator / rectifier lead.
4. Lift tab (A) and push forward to separate the 3-pin
connector.
5. Remove regulator / rectifier mounting screws (B).
B
6. Remove wires from wire guides.
16.16
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
FRONT
A
© Copyright 2012 Polaris Sales Inc.
7. Reverse order of removal to install. Be sure mounting
bracket is clean and all connections are clean and tight.
Secure wires and connectors, and torque all screws.
8. Torque circuit breaker nuts to 25 in-lbs (2.8 Nm).
85 in-lbs (9.6 Nm)
60 in-lbs (7 Nm)