Oil Pump Installation - Victory Cross Roads Classic Service Manual

LUBRICATION & COOLING

Oil Pump Installation

1. Refer to Fig. 2. Clean oil pipes and dry with
compressed air.
NOTE: After oil pump is installed, be sure the pump
rotates freely by installing the sprocket without the
chain and rotating pump a few revolutions.
2. Use new washers and O-rings upon assembly.
3. Install a backing washer (A) and lightly oiled O-ring (B)
onto short oil pipe. Insert pipe into pump body with a
twisting motion until seated.
4. Place washer (C) onto the other end of short oil pipe
followed by a new lightly oiled O-ring (D).
5. Install oil pump and short pipe into left crankcase. Start
by inserting oil pipe into rear of crankcase, then place
oil pump into crankcase alignment holes.
Use 1/4 inch pin punch
to align oil filter nipple to
oil pipe during installation
45 ft-lbs (62 Nm)
Tapered O-ring seat
faces oil pipe
Fig. 2
4.14
9924047 - 2012-2013 VICTORY Cross Roads / Cross Country Service Manual
K
A
D
C
© Copyright 2012 Polaris Sales Inc.
6. Start the top two oil pump retaining bolts (E) and the
rear pipe bolt (F) but do not tighten at this time.
7. Install new oiled O-rings (G) onto front of long oil pipe.
Install new washer (H) on end of pipe and a new
O-ring (I).
8. Fit front end of long oil pipe into position at front of
crankcase and rear of pipe through oil filter nipple
opening in crankcase. Install pipe retaining bolt (J).
9. Torque all pump fasteners to specification.
10. Install oil filter nipple (K). Center the oil pipe to the fitting
with a 1/4 inch pin punch as shown.
11. Temporarily install pump sprocket on pump shaft
(without the chain) and turn oil pump over by hand.
NOTE: Turn pump shaft by hand a few revolutions to
make sure it turns freely.
B
85 in-lbs (10 Nm)
F
85 in-lbs (10 Nm)
E
G
H
J
I
85 in-lbs (10 Nm)