Setting The Profisafe Address Using The Wago Parameterization Tool; Parameteriziation Of The F I/O Module With The Wago Parameterization Tool - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-667/000-003 4FDI/4FDO 24V/2A PROFIsafe V2 iPar
Coding switch is inaccessible when the I/O module is plugged in!
To set the PROFIsafe address on the coding switch, the I/O module must be
pulled out of the fieldbus node.
Use the switching elements of the coding switch to set the PROFIsafe address to
a value from 1 to 1023.
8.2.2 Setting the PROFIsafe Address using the WAGO
Parameterization Tool
Effectiveness using the WAGO Parameterization Tool
The PROFIsafe address set using the WAGO parameterization tool only takes
effect when the address set on the coding switch of the I/O module equals 0.
To configure the PROFIsafe address through storage in the parameter data set
of the I/O module, set the PROFIsafe address in the WAGO parameterization tool
to the required value and save the current parameter data set to the I/O module.
Configuring the F I/O module is described in the section "Parameteriziation of the
F I/O module with the WAGO Parameterization Tool".
8.3 Parameteriziation of the F I/O Module with the
WAGO Parameterization Tool
Only qualified persons may perform these tasks!
Adding, exchanging and starting up F I/O modules may only be carried out by
personnel trained in safety-related procedures!
Check safety functions!
Before start up, all safety functions must be checked for their specified
effectiveness!
Version 1.4.2, valid from HW/SW Version 01/02
Commissioning 85
Manual