Glossary - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-667/000-003 4FDI/4FDO 24V/2A PROFIsafe V2 iPar
13

Glossary

A
Acknowledgement
See "User acknowledgement (Operator Acknowledge (OA))"
Actuator
Final controlling element, valve, signal lamps, relays, motor contactor with
positively driven contacts (see also "Positively Driven Contacts, Positively Driven
Relays")
Antivalence
Two different input signals, e.g., open and closed contacts on two inputs of the
F I/O module
C
CAGE CLAMP
CAGE CLAMP
KG.
Cat. (category)
The categories (cat.) of EN ISO 13849-1 (B, 1, 2, 3 and 4) specify the required
behavior of a safe device in terms of its resistivity to errors based on its design.
Configuration Program
The configuration program is used to configure hardware and to create the safety
program of the safe PLC.
CPD Tool (Configuration Parametrization and Diagnosis Tool)
The CPD tool can be used to parameterize configure and diagnose device
functions of safe field devices (see also "WAGO Parameterization Tool" and
"WAGO Safety Editor 75x 2.x".
CRC (Cyclic Redundancy Check)
The cyclic redundancy check is a procedure for determining a test value for data
to detect errors during transmission or storage.
Cross Circuit
A practically unopposed conductive connection between two live electrical lines
(see also "Short Circuit").
Cross Circuit Test
The cross circuit test is used to discover a short circuit between two live lines
(see also "Short Circuit Test").
®
®
is a registered trademark of WAGO Kontakttechnik GmbH & CO.
Version 1.4.2, valid from HW/SW Version 01/02
Glossary 139
Manual