Table 3: Legend For The Ipar Server Figure - WAGO -I/O-SYSTEM 750 Manual

18 PROFIsafe

Table 3: Legend for the iPar Server Figure

No. Explanation
1 Instantiation of the iPar Server function
2 CPD Tool Start and parameter transfer (e.g., node address)
3 Parameterization of individual module parameters (iPar) and
commissioning
4 Transfer of iPar signature (CRC via the individual parameters) to the F-Host
5 During start-up, transfer of the signature to F-slave (Prm_Telegram)
6 Message to iPar server about diagnostic agent (alarm/status)
7 iPar server polls Diag FB and starts "Save" if required
8 iPar server polls Diag FB and starts "Restore" if required
Use the application notes from WAGO!
An overview for using the F I/O module in combination with a safe PLC is
summarized in an application note. This application note is available on the
Internet at www.wago.com under "Service > Downloads > Application Notes ...".
Manual
Version 1.4.2, valid from HW/SW Version 01/02
750-667/000-003 4FDI/4FDO 24V/2A PROFIsafe V2 iPar
WAGO-I/O-SYSTEM 750