Commissioning; Parameterization With Wago-I/O-Check - WAGO 750-486/040-000 Manual

WAGO-I/O-SYSTEM 750 XTR
750-486/040-000 4AI 0/4-20mA NE43 Ex i XTR
7

Commissioning

7.1

Parameterization with WAGO-I/O-CHECK

The WAGO-I/O-CHECK software from WAGO Kontakttechnik GmbH & Co. KG
can be used to conveniently and completely configure and parameterize the I/O
module. You have the following options.
• Graphical display of bus nodes
• Display of the measured values
• Settings for the application
• Configuration of the I/O module operating modes
• Parameterization of module, channel and scaling settings
• Calibration of channels and adjustment of analog inputs
• Monitoring
WAGO-I/O-CHECK
You can obtain the WAGO-I/O-CHECK software on a CD under Item No. 759-
302. This CD contains all the application program files and an explanation. You
can find a description at the internet page at
Save all your settings before you begin parameterization!
To be on the safe side you should always save all of your current settings in a
parameter file before you begin parameterization. This allows you to always use
the original values, should any parameters you are defining not be correct.
Commissioning
http://www.wago.com
57
Manual
Version 1.0.0