Adding Or Replacing Components; Setting The Profisafe Address; Setting The Profisafe Address Using The Coding Switch - WAGO -I/O-SYSTEM 750 Manual

84 Commissioning
The date of manufacture (calendar week/year) marks the beginning of the proof
test interval.
The proof test interval is specified in the technical data of the respective
F I/O module.
At the end of the proof test interval, the usage duration of the F I/O module is
also reached. The F I/O module must then be replaced.
8.1.2

Adding or Replacing Components

If F I/O modules are added to a fieldbus node (see section "Mounting" > ... >
"Inserting and Removing Devices") or replaced (see section "Service" > ... >
"Replacing an F I/O Module"), the associated safety function should undergo
additional testing before starting up the machine or system.
8.2

Setting the PROFIsafe Address

The PROFIsafe address can be set by the coding switch of the I/O module or by
the WAGO parameterization tool.
The PROFIsafe address set on the coding switch of the I/O module has priority
over the PROFIsafe address set by the WAGO parameterization tool.
Only when the address set on the coding switch equals 0 does the setting of the
PROFIsafe address using the WAGO parameterization tool take effect.
Default status address setting
In the default status, the address setting by the coding switch is active.
8.2.1

Setting the PROFIsafe Address using the Coding Switch

Disconnect the power from the node before making the settings!
Switch off the fieldbus node before you pull the F I/O module out of the fieldbus
node to change the settings!
Use only appropriate tools to change the settings!
To set the switching elements of the coding switch, use only suitable objects (e.g., test
prod or watchmakers screwdriver). Never exert pressure on the switching elements.
Manual
Version 1.4.2, valid from HW/SW Version 01/02
750-667/000-003 4FDI/4FDO 24V/2A PROFIsafe V2 iPar
WAGO-I/O-SYSTEM 750