Notes About This Documentation; Validity Of This Documentation; Copyright - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-667/000-003 4FDI/4FDO 24V/2A PROFIsafe V2 iPar
1

Notes about this Documentation

Always retain this documentation!
This documentation is part of the product. Therefore, retain the documentation
during the entire service life of the product. Pass on the documentation to any
subsequent user. In addition, ensure that any supplement to this documentation
is included, if necessary.
Technical Terms in this Documentation
The technical terms used in this documentation are available in the glossary at
the end of the manual.
1.1

Validity of this Documentation

This documentation applies to: "4FDI/4FDO 24V/2A PROFIsafe V2 iPar"
(750-667/000-003).
This documentation is only applicable from HW/SW Version 01/02.
The I/O module 750-667/000-003 shall only be installed and operated according
to the instructions in this manual and in the manual for the used fieldbus coupler
or controller.
Consider power layout of the WAGO-I/O-SYSTEM 750!
In addition to these operating instructions, you will also need the manual for the
used fieldbus coupler or controller, which can be downloaded at www.wago.com.
There, you can obtain important information including information on electrical
isolation, system power and supply specifications.
Observe the information on the power supply concept!
Detailed information and examples for supplying PROFIsafe I/O modules is
available in the section "Connect Devices" > ... > "Power Supply Concept".
1.2

Copyright

This Manual, including all figures and illustrations, is copyright-protected. Any
further use of this Manual by third parties that violate pertinent copyright
provisions is prohibited. Reproduction, translation, electronic and phototechnical
filing/archiving (e.g., photocopying) as well as any amendments require the
Notes about this Documentation
Version 1.4.2, valid from HW/SW Version 01/02
7
Manual