WAGO-I/O-SYSTEM 750
750-667/000-003 4FDI/4FDO 24V/2A PROFIsafe V2 iPar
10.1.3.2
PROFIsafe Address Set Using the Parameterization Tool
If the setting of the coding switch of the I/O module to be replaced represents the
value 0, the PROFIsafe address of the replacement I/O module must be set
using the parameterization tool (see section "Parameterization of the
F I/O Module with the WAGO Parameterization Tool"). In addition to setting the
PROFIsafe address, also configure the replacement I/O module using the WAGO
parameterization tool (see section "Commissioning" > ... > "Parameterization of
the F I/O Module with the WAGO Parameterization Tool").
Determine the PROFIsafe address if the coding switch is set to "0"!
You can use the WAGO parameterization tool to read the current PROFIsafe
address from the F I/O module to be replaced.
Version 1.4.2, valid from HW/SW Version 01/02
Service 123
Manual