Table of Contents
Advertisement
3.1
Setting the CANopen Station Address
To integrate the fieldbus coupler in the CAN network, the fieldbus coupler must
be assigned an station address that is unique across the network using DIP
switches. The address can be any number between 1 and 127. Use switches 1 – 7
to set the address.
Switch
Binary value/
Functions
Switch setting
Requirement:
The fieldbus coupler shall not be connected to the power supply.
To set the station address via the DIP switches, proceed as follows:
1.
Open the cover by unscrewing the M3 screw with a screwdriver.
2.
Set the CANopen station address by switching the switches 1 – 7 on ("On")
or off ("Off") accordingly. With the seven available switches, you can set
addresses from 1 – 127. Address 0 is reserved.
3.
Close the cover and screw it securely in place to maintain degree of
protection IP 67.
The CANopen station address is only active when the fieldbus coupler is
connected to the power supply.
WAGO-SPEEDWAY 767
Fieldbus Coupler for CANopen
1
2
3
4
5
0
1
2
3
2
2
2
2
2
(1)
(2)
(4)
(8)
(16)
Off Off Off Off Off Off Off
Note
6
7
8
9
4
5
6
2
2
Baud
Baud
(32)
(64)
Off
Off
Connection
17
10
11
12
-
Boot/
Reset
execute
Off
Off
Off
Advertisement
Table of Contents
