WAGO -I/O-SYSTEM 750 Manual page 136

136 Appendix
Table 51: PROFIsafe F Parameters
F Parameters
F_Block_ID
F_Par_Version
F_Source_Add
F_Dest_Add
Manual
Version 1.4.2, valid from HW/SW Version 01/02
750-667/000-003 4FDI/4FDO 24V/2A PROFIsafe V2 iPar
Default Value Description
The F_Block_ID parameter specifies the
format of the F parameter set. If F_Block_ID
has the value "0", the F_iPar_CRC parameter
is not included in the F parameters and the
iPar server is not used. If F_BLOCK_ID has
the value "1", the F_iPar_CRC parameter is
included in the F parameters and the F-I/O-
module can use the iPar server.
The F-I/O-module supports both formats. To
0 / 1
set this parameter, the correct F-I/O-module
must be selected for device configuration with
the configuration tool of the safe PLC:
F_Block_ID
0
1
The F_Par_Version parameter specifies the
PROFIsafe version to be used communication.
The F-I/O-module supports PROFIsafe V1
mode and PROFIsafe V2 mode and use the
V2 mode
version specified with this parameter:
F_Par_Version
V1 mode
V2 mode
The F_Source_Add parameter specifies the
PROFIsafe source address. To prevent
incorrect parameterization, the address of the
*)
– configuration tool is automatically assigned
and cannot be changed.
The parameter can accept values from
1 ... 65534.
The F_Dest_Add parameter specifies the
PROFIsafe destination address of the F-I/O-
module. For F_Dest_Add, values from
1 ... 65534 can be selected.
Each address value may appear in the system
*)
–
only once. This is checked by the configuration
tool of the safe PLC.
For PROFIsafe communication to begin, the
parameter value must match the PROFIsafe
address of the F-I/O-module.
WAGO-I/O-SYSTEM 750
Module designation
75x-667 4FDI/4FDO
24V/2.0A DC
75x-667 4FDI/4FDO iPar-
Server
Version
PROFIsafe V1 mode
PROFIsafe V2 mode