WAGO-I/O-SYSTEM 750
750-667/000-003 4FDI/4FDO 24V/2A PROFIsafe V2 iPar
3.1
Individual Parameters
The individual parameters are used to configure device functions of a safe device
such as the F I/O modules of the WAGO-I/O-SYSTEM 750. The "WAGO Safety
Editor 75x" parameterization tool (SEDI) can be used to set the individual
parameters of WAGO F I/O modules. SEDI is the CPD tool for WAGO F I/O
modules.
It is often required during a repair to quickly replace a device without using
additional manufacturer tools for parameterization of the device functions.
To meet this requirement, the iPar server is used that offers appropriate services
for saving and restoring individual parameters. The "iPar Server" is available as a
function block or as a system function within the non-safety related part of the
safe PLC.
Further details about using the iPar server in conjunction with the WAGO F I/O
modules are available in an application note.
Figure 3: iPar Server
Version 1.4.2, valid from HW/SW Version 01/02
PROFIsafe
17
Manual