KEB COMBIVERT F5-A Applications Manual page 88

Operating and appliance data
Parameter
In. Temperature mode
17
Parameter In.17 displays in high byte the temperature mode of the inverter. The desired function is adjusted
with Pn.72 and operates in accordance with the following table:
In. Function of T1, T2
17
PTC
0xh (in accordance with DIN
EN 60947-8)
KTY84 (standard)
5xh
PTC
(in accordance with DIN
EN 60947-8)
6xh PT100
The column is valid at factory setting and Ud.02 ≥ 4 (F5-Multi, Servo). At Ud.02 < 4 (F5-General) the
1)
function must be programmed accordingly with parameters Pn.12, Pn.13, Pn.62 and Pn.72.
The disconnection is depending on the adjusted temperature in Pn.62.
2)
Parameter
In.22 User parameter 1
In.23 User parameter 1
This parameters are not assigned to any function and are available to the user for input.
Parameter
In. Last error
24
In.24 stores the 8 errors that occurred last. The display is set-programmable. E. UP is not stored. The error
messages are described in chapter 8. If the value 0 is written, (only possible with supervisor password), all
error messages in all sets are deleted.
Page 7.1 - 18 COMBIVERT F5-A, -E, -H
Addr. R PG E
0E11h RO - -
Pn.72 Resistance
< 750 Ω
0.75...1.65 kΩ
(reset resistance)
-
1.65...4 kΩ
(tripping resistance)
> 4 kΩ
< 215 Ω
498 Ω
1 kΩ
0
1,722 kΩ
> 1811 Ω
< 750 Ω
0.75...1.65 kΩ
(reset resistance)
1
1.65...4 kΩ
(tripping resistance)
> 4 kΩ
-
Addr. R PG E
0E16h RW - -
0E17h RW - -
Addr. R PG E
0E18h R - -
Min. value Max. value
0 LTK
Display ru.46
T1-T2 closed
not defined
not defined
T1-T2 open
Detection error
1°C
100°C
200°C
Detection error 254
T1-T2 closed
T1-T2 closed
T1-T2 open
T1-T2 open
on inquiry
Min. value Max. value
0 65535
0 65535
Min. value Max. value
0 255
[?]
Res. Default
1 - LTK
1)
Error/ warning
-
-
x
x
x
2)
-
2)
x
2)
x
x
-
-
x
x
[?]
Res. Default
1 - 0
1 - 0
[?]
Res. Default
1 - -
© KEB, 2012-10