KEB COMBIVERT F5-A Applications Manual page 148

Setpoint, rotation- and ramp setting
Figure 7.4.3.a Absolute and 0 limited set value setting
0-limited
Setpoint
Rotation setting oP.02 ; (oP.01 = 0 or 1)
oP.02: Rotation setting
Bit Display
0 LS
1 F
2 R
Rotation adjustment via terminal strip
The rotation selection via terminal strip allows the adjustment of the direction of rotation via switch or from a
primary control.
Direction forward input selection (Run / Stop) oP.60, direction reverse (forward / reverse) oP.61
With parameter oP.60 one input is determined for rotation direction forward (or run/stop) and with oP.61 one
input for rotation direction reverse (or forward/reverse). (see chapter 7.3)
oP.01 = „2" or „3"
In forward/reverse rotation setting (oP.01= "2" or "3") the inputs determined with oP.60 and oP.61 work as fol-
lows:
forward reverse
F
0
0
1
1
oP.1 = „4" or „5"
Page 7.4 - 8 COMBIVERT F5-A, -E, -H
S e t p o i n t
a d j u s t -
ment
Setpoint rotation
Standstill (Low Speed)
forward (clockwise rotation)
reverse (counter-clockwise rotati-
on)
Input X2A.14
R Function
0 LS
F
1 reverse
0 forward
1 forward
absolute
Setpoint
X2A.15
R
Setpoint
a d j u s t -
ment
© KEB, 2012-10