KEB COMBIVERT F5-A Applications Manual page 333

Value Function
Number of the block with which the positioning sequence starts after the first "start positioning" com-
0...31
mand.
Start means the first positioning after:
●
Activation of the posi mode (e.g., by "power on" / setting of the input for activation of the posi mode /
activation of the posi mode via PS.00 or the control word).
●
Discontinuation of a running positioning (e.g., error message of the inverter / switching off of the control
release or new "start positioning command" during a running positioning).
The position selection via terminal strip can only be selected indirectly via parameter sets 0 ... 7 with PS.58.
With PS.56 and 57 it is possible to reach all 32 posi indices via the terminal (or IA, IB, IC, ID). Settings > 31 are
limited to 31 without error.
Value Meaning
0 PS.28
1 reserved
2 Terminal binary-coded
3 Terminal input-coded ST-I1-ID
4 Terminal input-coded ID-I1-ST
5 reserved
Bit -No. Decimal value
–
0
1
2
3
4
5
6
7
8
9
10 1024
11 2048
To clearly explain the sequential positioning, four examples are listed in the following:
© KEB, 2012-10 COMBIVERT F5-A, -E, -H
Posi- and synchronous operating
PS.28: Start index new profile
PS.56: Position target source
PS.57: Positon target input selection
Input
0 no input
1 ST
2 RST
4 F
8 R
16 I1
32 I2
64 I3
128 I4
256 IA
512 IB
IC
ID
Explanation
Target position selection occurs via set 0 ... 7 with PS.28.
–
Selected terminals are binary-coded (ST>RST>F>...ID)
Selected terminals are input-coded (ST>RST>...ID)
Selected terminals are input-coded (ID>IC>...ST)
–
7
Page 7.12 - 41