KEB COMBIVERT F5-A Applications Manual page 44

Selection of Operating Mode
This operating instruction is not valid for the G mode (V/f - characteristic open-loop mode, because the dis-
play is scaled in Hz, not in rpm). I.e. this instruction is not valid for controller types, which selects the G-mode
(F5-G / xxxHz).
Attention:
If a download list is downloaded to an inverter with another controller type, or if the COMBIVIS Config-File is
used for another controller type some parameters (e.g. set speed, speed limits, etc..) are not correctly displa-
yed.
COMBIVIS recognizes the use of inappropriate lists and select the correct config file automatically. Unintended
settings and wrong displays can occur if the warning messages are ignored.
The standardisation of some parameters is depending on the speed range of the control type.
S t a n - Speed range
dard
500...32000
1
128000
2
4000...128000
3 4000...64000
128000
4
128000
5
128000
Some parameters (ramp adjustments) have reference values, which are depending on the selected speed
range (500, 4000, 8000, 16000, 32000, 64000, 128000 rpm.
Page 5.1 - 4 COMBIVERT F5-A, -E, -H
Resolution
1 rpm
64000 2 rpm
4 rpm
500 1Nm
0.1 Nm
500 0.125 rpm
1 rpm
2 rpm
500 0.015625 rpm
4000 0.125 rpm
8000 0.25 rpm
16000 0.5 rpm
32000 1 rpm
64000 2 rpm
4 rpm
500 0.0015625 Hz
4000 0.0125 Hz
8000 0.025 Hz
16000 0.05 Hz
32000 0.1 Hz
64000 0.2 Hz
0.4 Hz
Parameter
SY.52, SY.53, SY.54
dr.27, dr.33, dr.40, dr.42, dr.44, dr.46
dr.01, dr.17, dr.18, dr.24, dr.39, dr.41, dr.43, dr.45, dr.47
cS.11, cS.12
Ec.25
nn.02, nn.03
dS.19
Sy.45
ru.01, ru.02, ru.06, ru.07, ru.09, ru.10, ru.63, ru.79, ru.85,
ru.86, ru.89
op.03, op.06, op.07, op.10, op.11, op.14, op.15, op.21, op.22,
op.23, op.40, op.41, op.64, op.65, op.66, op.67, op.68
Pn.32, Pn.37, Pn.41, Pn.48
dS.21
Le.16
cS.04
PS.08, PS.09, PS.21, PS.22, PS.25
nn.08
ru.03
uF.00, uF.02
© KEB, 2012-10