Table of Contents
Advertisement
4
Using the Cutting-Unit
Kickstand
Parts needed for this procedure:
1
Cutting-unit kickstand
Procedure
Whenever you need to tip the cutting unit to expose
the bedknife/reel, prop up the rear of the cutting unit
with the kickstand to make sure that the nuts on the
back end of the bedbar-adjusting screws are not
resting on the work surface
Figure 31
1. Cutting-unit kickstand
Secure the kickstand to the chain bracket with the
snapper pin
(Figure
32).
(Figure
31).
g003985
1. Chain bracket
2. Snapper pin
5
Installing the CE Hood Lock
Parts needed for this procedure:
1
Hood lock, seal, and jam nut
1
Washer
Procedure
1.
Unlatch and raise the hood.
2.
Remove the rubber grommet from the hole in
the left side of the hood
19
Figure 32
3. Cutting-unit kickstand
(Figure
33).
g004144
Advertisement
Table of Contents
