Other Fault Isolation Procedures; Abnormal Noise - Xerox Phaser 6600 Service Manual

Other Fault Isolation Procedures

Abnormal Noise

FIP-N1 Abnormal Noise: When Power is Turned On
Step Check
Possible causative parts:
• Toner Cartridge (Y, M, C, K) (PL5.1.8?PL5.1.11)
• Dispenser Motor (Y,M,C,K) [Upper Dispenser Motor
Assembly] (PL5.1.1)
• Main Motor [Drive Assembly] (PL3.1.1)
1 Check the Dispense Motor operation
Execute Digital Output diagnostic test 093-004(Y), 093-
006(M), 093-008(C), and 093-010(K), and check the
Dispenser Motor rotation.
Is the device making an abnormal noise?
CAUTION:
seconds, or the device will be damaged.
2 Check the Toner Cartridge installation
Reinstall the Toner Cartridge.
Turn the power off, and then on again. Is the device making
an abnormal noise?
3 Check the Main Motor operation
Execute Digital Output diagnostic test 071-001, and check
the Main Motor rotation.
Is the device making an abnormal noise?
CAUTION:
seconds, or the device will be damaged.
Xerox Internal Use Only
Stop the Motor operation within 3
Stop the Motor operation within 3
Error Troubleshooting
Yes
Go to step 2.
Replace the
Toner Cartridge.
If the trouble still
exists, replace
the device.
Replace the Main
Motor [Drive
Assembly].
Phaser 6600 and WorkCentre 6605
Service Manual
No
Go to step 3.
Finished.
Finished.
2-225