Wiring; Parametrization - YASKAWA VIPA System MICRO M13-CCF0000 Manual

VIPA System MICRO

5.3.3 Wiring

X6: DC 24V, AI, DO byte 1
X6 Function
1 Sys DC 24V
2 Sys 0V
3 Shield
4 AGND
5 AI 0
6 AI 1
7 DO 1.0
8 DO 1.1
9 DO 1.2
10 DO 1.3
Cables for analog signals

5.3.4 Parametrization

5.3.4.1 Address assignment
Sub module Input address
AI5/AO2 800
802
HB400 | CPU | M13-CCF0000 | en | 16-47
Type LED
I green
I
I
I
I
I
O green
O green
O green
O green
For the analog signals you have to use isolated cables. With this the interferences can be
reduced. The shield of the analog cables should be grounded at both ends. If there are
potential differences between the cables, a potential compensation current can flow,
which could disturb the analog signals. In this case, you should only ground the shield at
one end of the cable.
Temporarily not used analog inputs must be connected to the concerning
ground.
Access
WORD
WORD
Description
1L+: DC 24V for electronic section supply
1M: GND for electronic section supply
Shield
GND for analog inputs
Analog input AI 0
Analog input AI 1
Digital output DO 8
Digital output DO 9
Digital output DO 10
Digital output DO 11
Assignment
Analog input channel 0 (X6)
Analog input channel 1 (X6)
Deployment I/O periphery
Analog input > Parametrization
89