YASKAWA VIPA System MICRO M13-CCF0000 Manual page 171

VIPA System MICRO
Status indication
HB400 | CPU | M13-CCF0000 | en | 16-47
3. Switch on the power supply.
ð After a short boot time the interface X2 MPI(PB) is ready for MPI communica-
tion with the MPI address 2.
To switch the interface X2 MPI(PB) to PROFIBUS functionality
you have to activate the according bus functionality by means
of a VSC storage media from VIPA. By plugging the VSC
storage card and then an overall reset the according function-
ality is activated.
VSD, VSC' on page 79
1 RS485 interface
2 Periphery
Never connect the cable shield and the M5V (pin 5) together, since the
interfaces could be destroyed!
X2 MPI(PB) Description
DE
green n
n
n
green blinking n
n
n
n
Option: Deployment PROFIBUS communication
PROFIBUS communication via extension module EM M09
Ä Chapter 4.15 'Deployment storage media -
Slave is in DE (data exchange).
Slave exchanges data with the master.
Slave is in RUN state
Slave CPU is in state start-up.
Slave-CPU is without master.
There is no power supply.
Slave has no configuration.
171