YASKAWA VIPA System MICRO M13-CCF0000 Manual page 100

Deployment I/O periphery
Counting > Parametrization
Sub module Output address
Counter 816
820
824
828
5.6.4.2 Interrupt selection
5.6.4.3 Operating mode per channel
Parameter hardware con-
figuration
5.6.4.4 Counter
Parameter hardware con-
figuration
100
Access
DWORD
DWORD
DWORD
DWORD
Via 'Basic parameters' you can reach 'Select interrupt' . Here you can define the inter-
rupts the CPU will trigger. The following parameters are supported:
n None: The interrupt function is disabled.
n Process: The following events of the counter can trigger a hardware interrupt (select-
able via 'Count' ):
– Hardware gate opening
– Hardware gate closing
– On reaching the comparator
– on Counting pulse
– on overflow
– on underflow
n Diagnostics+process: A diagnostics interrupt is only triggered when a hardware inter-
rupt was lost.
Select via 'Channel' the channel select via 'Operating' the operating mode. The fol-
lowing operating modes are supported:
n Not parameterized: Channel is deactivated
Ä Chapter 5.6.5.1 'Count continuously' on page 104
n
Ä Chapter 5.6.5.2 'Count once' on page 105
n
Ä Chapter 5.6.5.3 'Count periodically' on page 108
n
Ä Chapter 5.7 'Frequency measurement' on page 117
n
Ä Chapter 5.8 'Pulse width modulation - PWM' on page 123
n
Depending on the selected operating mode default values are loaded and shown in an
additional register.
Default values and structure of this dialog box depend on the selected 'Operating mode' .
Assignment
reserved
reserved
reserved
reserved
HB400 | CPU | M13-CCF0000 | en | 16-47
VIPA System MICRO