Speed7 Studio - Hardware Configuration - I/O Modules - YASKAWA VIPA System MICRO M13-CCF0000 Manual

VIPA System MICRO

9.5 SPEED7 Studio - Hardware configuration - I/O modules

Hardware configuration of
the modules
Parametrization
HB400 | CPU | M13-CCF0000 | en | 16-47
5. Confirm with [OK].
ð The IP address data are stored in your project listed in 'Devices and
networking' at 'Local components' .
After transferring your project your CPU can be accessed via Ethernet PG/OP
channel with the set IP address data.
Local components
Slot Module
0 CPU M13-CCF0000
-X2 MPI interface
-X3 PG_OP_Ethernet
... ...
1. Click in the 'Project tree' at 'PLC... > Device configuration' .
2. Starting with slot 1 place in the 'Device configuration' yourSystem MICRO modules
in the plugged sequence. For this drag from the hardware catalog the corre-
sponding module to the corresponding position in the Device configuration.
For parametrization double-click in the 'Device configuration' on the module you want to
parametrize. Then the parameters of the module are shown in a dialog. Here you can
make your parameter settings.
Configuration with VIPA SPEED7 Studio
SPEED7 Studio - Hardware configuration - I/O modules
... ... ...IP address
...
...
172.20.120.40
...
...
187