YASKAWA VIPA System MICRO M13-CCF0000 Manual page 37

VIPA System MICRO
X2 Function
1 DO 0.7
2 DO 0.6
3 DO 0.5
4 DO 0.4
5 DO 0.3
6 DO 0.2
7 DO 0.1
8 DO 0.0
9 0 V
10 DC 24V
X3/X4: Ethernet PG/OP
channel
HB400 | CPU | M13-CCF0000 | en | 16-47
Type LED
O green
O green
O green
O green
O green
O
green
O
green
O green
I red
I
green
8pin RJ45 jack:
n The RJ45 jack serves as interface to the Ethernet PG/OP channel.
This interface allows you to program respectively remote control your CPU and to
n
access the internal web server.
n Configurable connections are possible.
n The connection happens via an integrated 2-port switch
DHCP respectively the assignment of the network configuration with a DHCP server
n
is supported.
n Default diagnostics addresses: 2025 ... 2040
n For online access to the CPU via Ethernet PG/OP channel, you have to assign IP
address parameters to this.
Ä Chapter 4.6 'Hardware configuration - Ethernet PG/OP channel' on page 61
L/A
(Link/Activity)
green
green blinking
green
green
not relevant: X
Description
Digital output DO 7
Digital output DO 6
Digital output DO 5
Digital output DO 4
Digital output DO 3 / Output channel counter 3
Digital output DO 2 / Output channel counter 2
Digital output DO 1 / PWM 1 / Output channel counter 1
Digital output DO 0 / PWM 0 / Output channel counter 0
4M: GND for onboard DO power section supply / GND
PWM
LED (red) is on at short circuit respectively overload
4L+: DC 24V for onboard DO power section supply
S Description
(Speed)
X The Ethernet PG/OP channel is physically
connected to the Ethernet interface.
X There is no physical connection.
X Blinking: Shows Ethernet activity.
yellow The Ethernet interface of the Ethernet
PG/OP channel has a transfer rate of
100Mbit.
The Ethernet interface of the Ethernet
PG/OP channel has a transfer rate of
10Mbit.
Hardware description
Structure > Interfaces
37