YASKAWA VIPA System MICRO M13-CCF0000 Manual page 235

VIPA System MICRO
Event ID
0xEC30
0xEC50
0xED10
HB400 | CPU | M13-CCF0000 | en | 16-47
Description
ZInfo2 : Diagnostics address of the station
ZInfo3 : AL Statuscode
DatID : Input address
DatID : Output address
DatID : Station not available
DatID : Station available
EtherCAT: Topology OK
ZInfo2 : Diagnostics address of the master
EtherCAT: DC out of sync
ZInfo2 : Diagnostics address of the master
ZInfo3 : DC State Change
0: DC master out of sync
1: DC slaves out of Sync
OB : Operation mode
0: Configuration in operation mode RUN
1: STOP (update)
2: STOP (overall reset)
3: STOP (own initialization)
4: STOP (internal)
5: Start-up (cold start)
6: Start-up (cold restart/warm start)
7: Start-up (restart)
8: RUN
9: RUN (redundant operation)
10: HALT
11: COUPLING
12: UPDATING
13: DEFECTIVE
14: Troubleshooting
15: Without power
0xFD: Process image enabled in STOP
0xFE: Watchdog
0xFF: Not set
EtherCAT: Bus failure
ZInfo1 : Old status
0x00: Undefined/Unkown
0x01: INIT
0x02: PreOp
System specific event IDs
235