YASKAWA VIPA System MICRO M13-CCF0000 Manual page 206

Configuration with TIA Portal
TIA Portal - Hardware configuration - Ethernet PG/OP channel
Assign IP address param-
eters
Take IP address parame-
ters in project
206
You get valid IP address parameters from your system administrator. The assignment of
the IP address data happens online in the Siemens TIA Portal with the following pro-
ceeding:
1. Start the Siemens TIA Portal.
2. Switch to the 'Project view' .
3. Click in the 'Project tree' at 'Online access' and choose here by a doubleclick your
network card, which is connected to the Ethernet PG/OP channel.
4. To get the stations and their MAC address, use the 'Accessible device' . This can
be found at the front of the CPU labelled as "MAC PG/OP: ...".
5. Choose from the list the module with the known MAC address (Onboard PG/OP
[MAC address]) and open with "Online & Diagnostics" the diagnostics dialog in the
Project area.
6. Navigate to Functions > Assign IP address. Type in the IP configuration like IP
address, subnet mask and gateway.
7. Confirm with [Assign IP configuration].
ð Directly after the assignment the Ethernet PG/OP channel is online reachable
using the set IP address data. The value remains as long as it is reassigned, it
is overwritten by a hardware configuration or an factory reset is executed.
Due to the system you may get a message that the IP address could not
be assigned. This message can be ignored.
1. Open your project.
2. If not already done, configure in the 'Device configuration' a Siemens CPU 314C-2
PN/DP (314-6EH04-0AB0 V3.3).
3. As Ethernet PG/OP channel place at slot 4 the Siemens CP 343-1 (6GK7
343-1EX30 0XE0 V3.0).
4. Open the "Property" dialog by clicking on the CP 343-1EX30 and enter for the CP at
"Properties" at "Ethernet address" the IP address data, which you have assigned
before.
5. Transfer your project.
VIPA System MICRO
HB400 | CPU | M13-CCF0000 | en | 16-47