YASKAWA VIPA System MICRO M13-CCF0000 Manual page 19

VIPA System MICRO
Insert wire
Remove wire
Standard wiring
HB400 | CPU | M13-CCF0000 | en | 16-47
The wiring happens without a tool.
Determine according to the casing labelling the connection position and insert
through the round connection hole of the according contact your prepared wire until
it stops, so that it is fixed.
ð By pushing the contact spring opens, thus ensuring the necessary contact pres-
sure.
The wire is to be removed by means of a screwdriver with 2.5mm blade width.
1. Press with your screwdriver vertically at the release button.
ð The contact spring releases the wire.
2. Pull the wire from the round hole.
(1) X2: 4L+: DC 24V power section supply for integrated outputs
X1: 3L+: DC 24V power section supply for integrated inputs
(2) X6: 1L+ DC 24V for electronic power supply
The electronic power section supply is internally protected against higher
voltage by fuse. The fuse is located inside the CPU and can not be
changed by the user.
Basics and mounting
Wiring > Wiring CPU
19