Parametrization - YASKAWA VIPA System MICRO M13-CCF0000 Manual

VIPA System MICRO
User program

5.8.4 Parametrization

5.8.4.1 Address assignment
Sub module Input address
Counter 816
820
824
828
Sub module Output address
Counter 816
820
824
828
5.8.4.2 Operating mode per channel
Parameter hardware con-
figuration
5.8.4.3 Pulse width modulation
Parameter hardware con-
figuration
HB400 | CPU | M13-CCF0000 | en | 16-47
n The SFB 49 should cyclically be called (e.g. OB 1) for controlling the pulse width
modulation.
n The SFB is to be called with the corresponding instance DB. Here the parameters of
the SFB are stored.
Access
DINT
DINT
DINT
DINT
Access
DWORD
DWORD
DWORD
DWORD
Select via 'Channel' the channel select via 'Operating' the operating mode. The fol-
lowing operating modes are supported:
n Not parameterized: Channel is deactivated
n Ä Chapter 5.6.5.1 'Count continuously' on page 104
Ä Chapter 5.6.5.2 'Count once' on page 105
n
Ä Chapter 5.6.5.3 'Count periodically' on page 108
n
Ä Chapter 5.7 'Frequency measurement' on page 117
n
Ä Chapter 5.8 'Pulse width modulation - PWM' on page 123
n
Depending on the selected operating mode default values are loaded and shown in an
additional register.
Default values and structure of this dialog box depend on the selected 'Operating mode' .
The following parameters are supported:
Pulse width modulation - PWM > Parametrization
Assignment
Channel 0: Counter value / Frequency value
Channel 1: Counter value / Frequency value
Channel 2: Counter value / Frequency value
Channel 3: Counter value / Frequency value
Assignment
reserved
reserved
reserved
reserved
Deployment I/O periphery
125