Mounting Periphery Module - YASKAWA VIPA System MICRO M13-CCF0000 Manual

VIPA System MICRO

2.4.3 Mounting periphery module

Proceeding
HB400 | CPU | M13-CCF0000 | en | 16-47
You have the possibility to extend the periphery area of the CPU by plugging up to 8
periphery modules. For this the periphery modules are plugged at the right side of the
CPU. The mountings happens with the following proceeding:
1. Remove the bus cover with a screwdriver on the right side of the CPU.
2. Each periphery module has a locking lever on its upper and lower side. Pull these
levers outwards as shown in the figure, until these engage audible.
CAUTION!
It is not allowed to mount the module sideways on the mounting rail,
as otherwise the module may be damaged.
3. To mount plug the periphery module from the top onto the mounting rail and turn the
periphery module downward until it rests on the mounting rail.
4. Attach the periphery module to the CPU by sliding the periphery module on the
mounting rail to the left until the interface connector slightly locks into the CPU.
5. To fix the periphery module at the mounting rail, move the locking levers back to the
initial position.
6. Proceed in this way with additional periphery modules.
Basics and mounting
Mounting > Mounting periphery module
17